What details should be paid attention to when using rivets?
The tools to be used when using rivets are manual rivet guns and pneumatic rivet guns. The manual rivet gun is operated by both hands of the worker. First swing the rivet gun away, then insert the rivet into the rivet gun, align the part to be anchored, and close the rivet gun to achieve the anchoring effect. The pneumatic rivet gun is operated with one hand, and now the suction rivet gun is fast. Pay attention to safety when using the rivet gun. The precautions for the rivet gun are: 1. The hole diameter of the rivet should be about 0.10mm larger than the diameter of the rivet. Too large a diameter will affect the connection strength, and too small a rivet will be difficult to penetrate. 2. When riveting, the diameter of the riveting gun head should be selected according to the diameter of the mandrel, properly adjust the orientation of the catheter and lock it with a nut, so that the mandrel can freely penetrate into the clamp of the catheter, and then pierce the rivet into the nail hole. Press the button, pull the mandrel off, and complete the riveting. 3. When choosing rivets, it is also necessary to pay attention to the following points: when drilling rivet holes, the aperture should be straight with the surface of the workpiece; when using rivets to check rivets, the rivet inspection axis must be the same as the rivet hole axis, and must not be Tilt, when pulling riveting, press the riveting gun with a little force, so that the rivet tail is close to the surface of the workpiece. steady-ind.com