Ring groove rivet refers to a special rivet. Ring groov […]
Ring groove rivet refers to a special rivet. Ring groove rivets are divided into large diameter ring groove rivets, small diameter ring groove rivets, continuous groove ring groove rivets, and short tail rivets (bobtail). Ring groove rivets are made of high-quality carbon steel, with high riveting strength and firmness and reliability. It is characterized by good anti-vibration performance, wide application, and convenient construction.
The ring-groove rivet is used for riveting two structural parts into a whole. It is composed of two parts: rivet and nail sleeve. The rivet consists of a nail rod and a nail sleeve. When riveting, first insert the rivet into the nail hole of the connected part, and then set the nail on the ring groove of the working section of the rivet from the other side of the connected part, and then use the special tool-the muzzle sleeve of the pneumatic ring groove rivet gun On the ring groove of the clamping section of the rivet, press the muzzle against the end face of the nail sleeve, and then pull the trigger of the gun, the rivet gun will tighten the ring groove nail rod of the clamping section of the rivet until it breaks. At this time, the inner wall of the nail sleeve is squeezed into the ring groove of the working section of the rivet to form a new rivet head, thereby riveting and fastening the connected piece. Its characteristics are: simple to use, high efficiency, low noise, good seismic resistance, so it is widely used in various vehicles, ships, aviation, mechanical equipment, building structures and other fields.